Display and Alarm Systems
Various audible, visual and output to BMS alarms for pump status or tank levels.
Level Monitor – Battery Powered- MacNivel
DIN Rail Mounted Level Controller with Alarms – Electroprobe DB
Pneumatic Level Gauge
Timeout / Leakage Detection Alarm
Tank Level Warning Display Kit
Level Monitor – Battery Powered- MacNivel
Monitoring the level of liquid in a tank. Suitable for any monitoring any conductive liquid as long as that does not damage the sensing wires (not included), for example rainwater, grey water, ground water, flood water.DIN Rail Mounted Level Controller with Alarms – Electroprobe DB
DIN rail mounted (4DIN, 76mm) conductivity probe level controller with external alarm relay. Available for various supply voltages from 24Vac, 117Vac and 230Vac.
Mac3 Electroprobe DB is a multifunctional level controller with 4 functions:
Differential Fill/Drain Function, activates a relay output to maintain the level between two probes set at different heights. The relay only changes state when either the upper probe becomes immersed or the lower probe becomes dry, allowing the water level to move between but not exceed the area between the two level probes. High Level Alarm – Activates the alarm relay when a probe is immersed.
Low Level Alarm – Activates the alarm relay when a probe becomes dry.
Single Point Control – Switches a 2nd control relay when a probe is immersed or dry. This can be used to inhibit/enable the device attached to the differential relay, or to enable an additional device.Pneumatic Level Gauge
The 3P Pneumatic Gauge measures the stored water level in your rainwater tank remotely, giving an accurate analogue reading in a convenient location on it’s large easy to read dial.Timeout / Leakage Detection Alarm
RCPM Series – Visual and Audible Pump Alarm The RCPM Series Display Panel provide a visual and audible alarm in the event of a pump run-time exceeding a pre-set limit, typically indicating a suspected leak or over-use due to an outlet being left open, faulty control system or disconnected pipework.Tank Level Warning Display Kit
RCALM Series – Tank level display (low or high level) The 3P RCALM Series Display Panels provide a highly effective low level warning for water tanks, Alternatively float switch wiring can be reversed on the RCALM1 and 2 Series to provide a high level warning instead.